Your cart is empty
Sanlianhuan Original Parts

30A Programmable Brushless Motor ESC w/2A BEC

* One time charges may apply
US$23.95
Always Free Shipping
Start from: Unit(s)

Share |


Please Choose:



* One time charges may apply

This Brand New Programable Outrunner Brushless motor ESC Speed Controller. It is very easy to setup and program. Most of the settings are auto-detected. Also, it is made with higher quality micro processor and more FETs with lower internal resistance. The best for airplane or helicopter.

Feature:
- Operating Current(A): 30A(40A surge)
- Input Operating Voltage: 7.4v ~ 14.8v (Compatible with NiCd, NiMH and LiPo batteries)
- BEC Max output: 2A/5V
- Dimention(LxWxH): 26*50*11.5mm
- Weight: 21.5g
- Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM, 35,000rpm for 12 poles BrushLess Motor
- Programmable low voltage cutoff for Lipo and Nimh/Nicad Reverse and brakeand many more programmable options

Package Content
- Brand New Brushless Motor 30A ESC (Electronic Speed Control) x1
- FREE 24K gold-plated connectors & heat shrink tube x3 pairs

Hobbyhack ESC

- Safety Arming Feature: Regardless the throttle stick position, the motor will not spin after battery connected.
- Throttle Calibration: Throttle range can be configured to provide best throttle linearity, fully compatible with all market available transmitters.
- Programmable Items:
-- Brake Setting: brake enabled / brake disabled.
-- Battery Type: Li-xx(Li-ion or LiPo) / Ni-xx(NiMh or NiCd).
-- Low Voltage Protection Mode(Cutoff Mode): Gradually reduce the output power / Cutoff the output power. Low Voltage Cutoff Protection Threshold (Cutoff Threshold): low / medium / high.
-- Start Mode: normal / soft / very soft.
-- Timing: low / medium / high.
-- Reset: reset all the programmable items to their default settings.
- Full Protection Features: Low voltage cutoff protection / Over-heat protection / Throttle signal lost protection.

NOTE:
- When setting to the Quick response speed, the accelerate peak current will increase.
- To minimize possible radio interference induced by switching power system, BEC should be installed at least 5cm away from the receiver. The use of PCM receiver is recmmonded.

User Manual


  • Model: HH-ESC-30A
  • Shipping Weight: 0.1kg
  • 47 Units in Stock
  • Manufactured by: HobbyHack